Community
Fusion Manufacture
Talk shop with the Fusion (formerly Fusion 360) Manufacture Community. Share tool strategies, tips, get advice and solve problems together with the best minds in the industry.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Tool compensation not working in Haas pre-NGC with tool probe

0 REPLIES 0
Reply
Message 1 of 1
jagSJMV8
56 Views, 0 Replies

Tool compensation not working in Haas pre-NGC with tool probe

I have a problem I cannot figure out with probing and cutter compensation in Haas pre-NGC with Renishaw Probe. These two programs when the Renishaw has scanned the tools cut vastly different with the in control cutting about 2.5mm deeper with the in control setting on 2D contour (tested two different tools)

 

Somehow it seems like the Haas preNGC controller cannot handle this, but it might just be settings as Fusion 360 tends to erase settings on updates.

 

Any idea where to look?

It sounds like it is a post processor setting or a Haas controller setting that is giving conflict. It would be nice to neither scrap parts or break tool when we use in control or similar

 

 

0 REPLIES 0

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums