Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Syntax error post processor mac

rom_gerrun
Explorer

Syntax error post processor mac

rom_gerrun
Explorer
Explorer

Hi guys,

 

So I'm working on a mac and trying to figure out a Heidenhain post pro for a 5axis dmu50

 

Since I'm working on a mac I had to make a change to the PP to actually work.

 

Here is the procedure:

https://knowledge.autodesk.com/support/autodesk-hsm/troubleshooting/caas/sfdcarticles/sfdcarticles/E...

 

But I still have a syntax error and don't understand it

 

Iv'e attached the pp and also the error I have when post the code.

 

Thanks for the help 

0 Likes
Reply
Accepted solutions (2)
338 Views
2 Replies
Replies (2)

randyT9V9C
Collaborator
Collaborator
Accepted solution

You are missing commas at the end of lines 60 and 85. Syntax is sometimes hard to see but it will get you everytime.

 

60   preferTilt: "-1", // -1: negative, 0:dont care, 1: positive TAG: Mac

85   preferTilt: {title:"Prefer tilt", description:"Specifies which tilt direction is preferred.", type:"enum", values:[{id:"-1", title:"Negative"}, {id:"0", title:"Either"}, {id:"1", title:"Positive"}]     }, // TAG: Mac

 

I've attached the corrected post processor.

 

Screen Shot 2020-08-15 at 9.50.50 AM.png

0 Likes

rom_gerrun
Explorer
Explorer
Accepted solution

Hey perfect it worked.

 

Tank you for the help 

0 Likes