Line 3 of code snippet below shows an X value change of 0.0009 at the transition point between the cylindrical profile and the dome profile. This is leaving a visible line in the part.
Tried a few different tolerances, post versions, etc, same results. Drew this test version in Fusion, so the arc and the line are tangent to each other.
G1 X1.8125 F0.003
Z0.8932
X1.8116
G3 X-0.0312 Z0. I-0.9214 K0.0287
G1 Z-0.08
Enabling spun profile seems to fix it. That said probably should not be needed on this simple example.
Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Also found the tangential extension at the front seems to be causing the problem. If I set it to zero with spun profile disabled the short line move disappears. You can set a distance to cut below the inner radius on the Radii tab. Edit, it doesn't look like the tangential extension is actually doing anything in this situation.
See attached file.
Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Could be it just introduces a floating point error. One for @akash.kamoolkar to take a look at maybe.
Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
@jonathanBUCVS this issue was fixed in the latest update that went out.
Regards,
