Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Simulation: False positive collision

eerier_bleach0f
Advocate

Simulation: False positive collision

eerier_bleach0f
Advocate
Advocate

There is no collision but Fusion says there's 2 per bore at different points:

Screenshot 2024-05-03 at 1.04.52 PM.png

 

 

It's close at one point but there's no collision.

 

Screenshot 2024-05-03 at 1.07.01 PM.pngScreenshot 2024-05-03 at 1.07.05 PM.pngScreenshot 2024-05-03 at 1.07.10 PM.pngScreenshot 2024-05-03 at 1.07.14 PM.png

 

Top height is below the top of the bore, BUT 5 thou above the bottom height of the previous bore toolpath. It's plastic so I want to remove the stringy chips before continuing boring the hole, I have 4 bore toolpaths all milling progressively deeper but always starting 5 thou above the previous bore's bottom height. All 4 have false positive collisions.

Autodesk's most dedicated bug reporter: https://forums.autodesk.com/t5/user/viewprofilepage/user-id/15188348
0 Likes
Reply
Accepted solutions (1)
285 Views
1 Reply
Reply (1)

seth.madore
Community Manager
Community Manager
Accepted solution

I'm not seeing these on my end. Looking at your recent video, the supposed collision isn't happening between the holder and the part, it's happening between the shaft and the part. As in the other thread, do you have Stock Sim Improvements turned on?


Seth Madore
Customer Advocacy Manager - Manufacturing
0 Likes