Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Shaft and holder pull away cut the lead-in radius

marcoCAGYK
Contributor

Shaft and holder pull away cut the lead-in radius

marcoCAGYK
Contributor
Contributor

Hello,

when I select pull away or trimming in the shaft and holder menu the tool goes with the correct distance from the model, but in that point it cut the lead-in radius, only in that point, and the tool enter in plunge in the model and creates a bad surface finish. There is a way to maintain the lead-in when the tool go away from the model?

Thanks

Marco

0 Likes
Reply
214 Views
3 Replies
Replies (3)

marcoCAGYK
Contributor
Contributor

Sorry I forgot to write that happen when I use the 3D contour strategy

0 Likes

jodom4
Community Manager
Community Manager

Hey marcoCAGYK,

Please share your model here- you'll be much more likely to get better help faster.


Jonathan Odom
Community Manager + Content Creator
Oregon, USA

Become an Autodesk Fusion Insider



0 Likes

marcoCAGYK
Contributor
Contributor

I'm trying to do the 3D contour of the model attached, whit a tool body lenght 50mm.

 

0 Likes