Talk shop with the Fusion (formerly Fusion 360) Manufacture Community. Share tool strategies, tips, get advice and solve problems together with the best minds in the industry.
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Selected 3D data not understood / not following correct geomety
Selected 3D data not understood / not following correct geomety
Received a .step file for a quote, the problem is that whenever i select a pocket to machine it selects a much larger area. Not sure technical term to describe it, so heres a picture.
same goes for all other areas on the engraving. I can usually get around this by creating a sketch and projecting the pockets, then filling in the missing lines. However, there are probably 250 lines in this sketch.
The "overspill" Blue areas will not be machined, it is just a "glitch" in the software, as long as you select the correct areas and make sure the Red arrow is inside then it will work OK 🙂🙂🙂
Fusion
