Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Right angle head attachment

Anonymous

Right angle head attachment

Anonymous
Not applicable

Hi,  

Is there a way to use a right angle head attachment with Fusion cam? 

 

Thank you in advance.

0 Likes
Reply
1,104 Views
3 Replies
Replies (3)

LibertyMachine
Mentor
Mentor

There are no "built in" solutions to speak of. It is doable, but it would require a fair amount of post processor editing, as the axis would need to be changed and drill cycles would be long hand, again, with axis substitution (Z becomes X or Y, vice versa)


Seth Madore
Owner, Liberty Machine, Inc.
Good. Fast. Cheap. Pick two.
0 Likes

Lonnie.Cady
Advisor
Advisor

Why would you need to use axis substitution?  I once worked at a shop that did it that way but when I went into programming we did it with G17, G18, G19 and got away from axis substitution.  This was for a right angle head on a large VTL.

1 Like

LibertyMachine
Mentor
Mentor

That's....a good point. Perhaps I'm overthinking it. I was looking at it from the Fusion side of things and not the machine. I'll try to test that out if I have time today.


Seth Madore
Owner, Liberty Machine, Inc.
Good. Fast. Cheap. Pick two.
0 Likes