Request for C AXIS post processor for FANUC

[Aadithya01]

Hey Guys,

I have been trying for a while to post process a 4 axis program along the z Axis (i.e C AXIS) - positional 4th axis and I tried to change the post processor too . Like mentioned in these forums and yet I didn't get the solution . Can anyone please help me out I am struck ??

http://forums.autodesk.com/t5/hsm-post-processor-forum/how-to-set-up-a-4-5-axis-machine-configuratio...

Can anyone please help me out I am struck ??

ALSO I have attached the my post processor that I tried for FANUC.

[LibertyMachine]

I found some good stuff over on the Post Forum. Try reading these threads and see if they get you close to a solution:

Read first: http://forums.autodesk.com/t5/hsm-post-processor-forum/doosan-puma-fanuc-millturn-post/td-p/6099370#...

http://forums.autodesk.com/t5/hsm-post-processor-forum/mill-turn-posts-availibility/m-p/6082177/high...

[Aadithya01]

Hey @LibertyMachine

Do you have any 4th axis processor .cps file that is running successfully. All I want is along with the XYZ I want the C axis say 0 degree . Then for the next drill C36 , C72 , etc..

Just the indexing along Z Axis . Can you share any of your post processors

[LibertyMachine]

Sorry, I don't even have a lathe yet (just mills), I've spent very little time working on lathe posts

[Aadithya01]

I am asking for a 4th axis Milling machine .. Which has an indexer installed in it... The best example is the Machine is a large scale model of a Pocket NC

[daniel_lyall]

Can you post a picture of your 4th axis set up, whats on the HSM post form page has how to do the A, B and c axis. 

[Aadithya01]

I am trying the 4th axis - C Axis output for our customer .Tomorrow I will be going to his factory , I will take a photo there and I will post it in this forum. Remember that I had asked engrave wrap toolpath where you had told me about that CAM betamode . I am asking for that prospect only

[daniel_lyall]

You meaning how this pick shows for the C axis. 

[Aadithya01]

YEs Exactly .. 

Also I have changed the post processor as mentioned in this forum

http://forums.autodesk.com/t5/hsm-post-processor-forum/how-to-set-up-a-4-5-axis-machine-configuratio... ... - Still I am not getting the solution ... 

Also I have attached the post processor .cps file of mine .. Kindly see that @daniel_lyall

[daniel_lyall]

I would not have a clue how to do it, you have already done what I know what to do, what is the machine does it have a right angled head on it, going by your pick in the first post you wont to go side ways what would need a B axis or a right angle head.

Or is it a horizontal mill.

[Aadithya01]

It is a Turn / mill center