Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Ramp on multiple depths

gastontaiba
Participant

Ramp on multiple depths

gastontaiba
Participant
Participant

I´m having an issue when using ramp entry and multiple depths, I want to use a 10 deg angle ramp, but it only changes the angle on the first pass, on the second pass the angle is still 2 deg. Anyone else having this problem?

Thank You.

Gaston.

0 Likes
Reply
513 Views
3 Replies
Replies (3)

HughesTooling
Consultant
Consultant

Someone else reported this awhile ago, the workaround was to set the Maximum Ramp Step to a really big number. As you've set multiple depths you should be safe with the Max Step set high.

 

Mark

Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

EESignature


0 Likes

kbpav
Participant
Participant

will this problem be fixed?

0 Likes

vandyckaj
Enthusiast
Enthusiast

This is super annoying. Setting the max ramp step down to like 100 inches is a workaround. But... They should at a minimum fix it so the ramp settings apply globally to the step downs in the contour toolpath, or if they wanted to take it a step further, what would be even more awesome is to just have a separate ramp settings dialogue in the step down toolpath portion. That way one could have an entry ramp set one way, and then a different ramp parameter after initial step down. 

0 Likes