Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Radial stock using trace.

Anonymous

Radial stock using trace.

Anonymous
Not applicable

There is a raidial stock check box while using tracing but it doesn't do anything. Is it possible to use this feature? The axial stock works but why is the radial stock even an option?

 

Thanks,

Brian

0 Likes
Reply
689 Views
4 Replies
Replies (4)

hansun_zhu
Autodesk
Autodesk
HI Brian,

Did you mean the radial stock to leave?

Thanks
Hansun
0 Likes

fonsecr
Autodesk
Autodesk

The radial stock to leave is used when you choose Sideways Left and Right compensation. But it is not used when using the Center compensation (which is the default).

 

We will see if we can get the radial stock grayed out when Center is active to avoid confusion.

 

Thanks.

 


René Fonseca
Software Architect

0 Likes

tnfjield
Enthusiast
Enthusiast

To revive an old thread, I just found out over the last couple of days that radial stock to leave is ignored when sideways compensation is set to center.

 

This really should be greyed out or disabled when set to center to avoid confusion (and wasting time with trial and error).  

0 Likes

mathew.hutton
Alumni
Alumni

Hi @tnfjield @Anonymous 

 

I'll submit a ticket to development on this so that the option is either removed or grayed out if tool center compensation is selected. 

 

Cheers

 

Mat



Mathew Hutton
Manufacturing Specialist
0 Likes