programming double angle cutter for deburring tubes
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
This is my first time programming a double angle cutter for deburring. I feel like I have the top hole in the tubing figured out, though if you have any suggestions for a cleaner way to do it I'm open. My main problem is that I can't figure out how to get the bottom hole without the tool retracting out all the way between deburr bottom 1 and deburr bottom 2. Any help or suggestions are greatly appreciated.
See attached file the toolpaths in question are in the set up folder labeled Double angle deburr.
Roger.
Fusion