Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Profile roughing strategy error.

evanmaunder
Participant

Profile roughing strategy error.

evanmaunder
Participant
Participant

When using profile roughing Cycle with direction Vertical, outside in, allow radial & axil grooving an error occurs that allows the tool to enter stock in rapid mode.

 

File attached, problem with 2nd setup T7

0 Likes
Reply
Accepted solutions (1)
235 Views
4 Replies
Replies (4)

a.laasW8M6T
Mentor
Mentor

That is because your Front Mode was set to Model front so It was ignoring the positive stock in front of the model.

Set it to Stock Front

alaasW8M6T_0-1707282782067.png

 

and change the outer radius to a selection of the outer part of the cone

alaasW8M6T_1-1707282827691.png

 

That should get you what you want

 

0 Likes

evanmaunder
Participant
Participant
The stock makes no difference, if you look at the position when simulating it goes into the model by -0.35mm. I also checked this by removing stock on the front and it still went into model in rapid mode. the only way around this was adding 0.5mm to model front.
0 Likes

a.laasW8M6T
Mentor
Mentor
Accepted solution

I cannot see it doing that

 

I do notice you are using "Tip" for the compensation point rather than "Tip tangent"

alaasW8M6T_0-1707344810729.png

 

 

How are you measuring the tool in the machine?

I suspect that will likely be the issue

2 Likes

evanmaunder
Participant
Participant
That was it, the tool tip was not set to tangent, I missed that detail. good pickup.
0 Likes