Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Problem with Lathe roughing not using outer radius of stock

sstephe1622
Advocate

Problem with Lathe roughing not using outer radius of stock

sstephe1622
Advocate
Advocate

Any one else have an issue were the lathe roughing will not use the settings in outer radius? 

0 Likes
Reply
506 Views
11 Replies
Replies (11)

akash.kamoolkar
Autodesk
Autodesk

@sstephe1622 Can you attach your file here so i can take a look at it

 

Regards,

Akash Kamoolkar



Akash Kamoolkar
Software Development Manager
0 Likes

sstephe1622
Advocate
Advocate

Look at "Lathe Back" roughing operation.  I tried increasing the stock size in setup.  I also tried changing clearance and outer radius with the same result.

0 Likes

akash.kamoolkar
Autodesk
Autodesk

@sstephe1622 

This problem was fixed a while ago. Are you using the latest Fusion release?

 

Untitled.png



Akash Kamoolkar
Software Development Manager
0 Likes

Anonymous
Not applicable

I don't see any problems with settings in right place.

 

 

2020-01-10 11_23_51-Autodesk Fusion 360.png

0 Likes

sstephe1622
Advocate
Advocate

Yeah using the latest release.

0 Likes

akash.kamoolkar
Autodesk
Autodesk

@sstephe1622 

I too regenerated the toolpath in the file you sent me in the latest Fusion update and I am not seeing the issue. It's machining the correct area.

 

Regards,

Akash Kamoolkar



Akash Kamoolkar
Software Development Manager
0 Likes

sstephe1622
Advocate
Advocate

When I load you file the tool path comes in as you have it on screen.  But when I regenerate the tool path it comes in ignoring the stock.  See attached screen shots....Does this mean something in Fusion360 didn't get updated and I should reinstall?

0 Likes

Anonymous
Not applicable

It appears that problem is with your computer or installation of Fusion and not Fusion itself.

0 Likes

sstephe1622
Advocate
Advocate
VicKosta sent me a file that shows the correct tool path.  But when I regenerate on my end using his file it ignores that stock....Here is a screen shot of the file VicKosta supplied me after I regenerated the tool path.  Could it be that what ever got fixed didn't get updated on my system and that is why I'm having the problem?

0 Likes

akash.kamoolkar
Autodesk
Autodesk

@sstephe1622 

close your fusion and restart it. If that doesn't work restart your computer. Try this to see if it works otherwise uninstall and reinstall Fusion.

 

Regards,

Akash Kamoolkar



Akash Kamoolkar
Software Development Manager
1 Like

sstephe1622
Advocate
Advocate

I uninstalled and reinstalled Fusion360 but still get the same result.  But if I create a new roughing tool path I get the desired tool path...Any idea's?

0 Likes