Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Please Help Machining This Part

kegarc2002
Enthusiast

Please Help Machining This Part

kegarc2002
Enthusiast
Enthusiast

Hi guys:

Can someone please help me machine this part? I have 3 different issues.

1_Can't make it machine the bottom surface of this spiral "pockets".

2_I can't make the Trunnion to rotate and machine the part in the front of the table.

3_Am I using the right strategies to run this part?

Please, Maybe I am not using the right multi-axis strategy. I'm new in 5 Axis.

Thanks in advance.

 

0 Likes
Reply
Accepted solutions (1)
212 Views
2 Replies
Replies (2)

a.laasW8M6T
Mentor
Mentor
Accepted solution

Hi

 

To get the trunnion to face towards you, edit the machine definition and set the preference for the A axis to positive

alaasW8M6T_0-1709412123428.png

 

To machine the floor of the spirals you can use Blend or Geodesic, I have attached a file with some examples.

Blend seems to give the nicest results in this case.

 

Using Rotary pocket and rotary contour is a good choice for roughing and finishing the walls of a part like this so you were spot on with those selections

2 Likes

kegarc2002
Enthusiast
Enthusiast

Thank you a.laasW8M6T for the help and the fast response. When I posted this part issue, I did it with you in mind.

I knew if you read it, you had the solution.

I'm gonna get into the examples files, I'll let you know if I get in trouble.

Thank you again for the help. 

 

1 Like