- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
On the attached file, the first Parallel operation is plunging the first pass way too deep. I have it set at 2mm multiple depths. The simulation shows it makes 2 passes. No matter what I set the pass depth to be, it sets the number of passes to 2. When I start to mill the model (using styrofome as a test stock)it plunges to 8-10 mm to mill the first pass. The second pass is milled at the correct 2mm depth.
How do I set this up so that is mills no more than 2mm depths for each pass?
Thank you for your advise.
Bill
Solved! Go to Solution.
Fusion