Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

need to reset The grbl post that ships with Fusion

Anonymous

need to reset The grbl post that ships with Fusion

Anonymous
Not applicable

All advise welcome. I have an X-Carve and installed the Easel post processor, now the only post processor that shows up in the drop down list is Easel. Want to bring back what came with Fusion 360. Any help with this greatly appreciated.

0 Likes
Reply
Accepted solutions (2)
832 Views
4 Replies
Replies (4)

Steinwerks
Mentor
Mentor
Accepted solution

In the screenshot you'll see the Setup button on the righthand side. Click this and scroll down to "Use Generic Posts":

 

Generic Posts.jpg

Neal Stein

New to Fusion 360 CAM? Click here for an introduction to 2D Milling, here for 2D Turning.

Find me on:
Instagram and YouTube
1 Like

Anonymous
Not applicable

Hey thanks for the quick response. I did what you said and i'm back where i want to be.  If you could you be so kind as to recommend a  generic processor for use with an X-carve CNC?

 

Thank you,

 

Andrew 

0 Likes

Steinwerks
Mentor
Mentor
Accepted solution
After a quick glance over their G-code spec ( https://inventables.desk.com/customer/portal/articles/2258567?b_id=9562&t=0 ) I would probably start with the RS274D or Generic Fanuc posts, but those are comfortable for me and I have no experience with the X-Carve machines at all. It will likely involve troubleshooting and altering the posts. Hopefully someone with knowledge of those machines can chime in, or you can ask on the Inventables forums: https://discuss.inventables.com/
Neal Stein

New to Fusion 360 CAM? Click here for an introduction to 2D Milling, here for 2D Turning.

Find me on:
Instagram and YouTube
1 Like

Anonymous
Not applicable

Hey thanks Steinwerks,

 

Will try those and take your advice and consult Inventables community.

 

Andrew

0 Likes