- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
I have a Clausing Lathe with a Fanuc 21iTB control.
If I post NOT using CANNED cycles everything seem to work fine but when using CANNED cycles I get errors in the G71-76
If I post in A B & C then compare the G71 lines there is no difference but get errors when it gets to those lines.
I went to the manual and went through each line of the G71 cycle, all seems to be correct.
Probably something simple.
Any help or suggestions are greatly appreciated
Solved! Go to Solution.
Fusion