- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
Hello,
For a few days now I've been trying to get my new to me Linco LNC42 Lathe with the Meldas 500 up and running with Fusion 360. I've tried to start with the post files from Fusion post library and found the Mitsubishi to somewhat work except, I'm stuck with arc errors with the I J K lines throwing the errors. Mitsubishi P70 Arc Error. I've changed my tolerances and lead in and out angles and with no luck. I did change the Radius Arcs to yes and it ran the code but it acted funny.
G18 G3 X0.842 Z-0.3656 I-0.0567 K-0.1439------this is the code that stops me in my tracks.
Any suggestions would be appreciated
Attached is the Post and the posted file.
Thanks
Solved! Go to Solution.
Fusion