Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Machining fillets

Richie_B
Enthusiast

Machining fillets

Richie_B
Enthusiast
Enthusiast

Hi

I would appreciate any help on machining the top fillet on the enclosed file.

I would like to use a Ø8.0 mm bull nose end mill with a 0.5mm corner rad and maybe something like a 3d contour toolpath

 

thanks in advance

Richie

 

0 Likes
Reply
306 Views
4 Replies
Replies (4)

HughesTooling
Consultant
Consultant

Here's a couple of ways.

3D contour, advantage is smaller program and better smoothing. Disadvantage is not a constant stepover on the surface.

 

Scallop, Advantage is a more constant stepover but if you look at the corners you'll see it's quite wavy in the Z axis so you don't get good smoothing and arc fitting.

Files attached.

 

Mark

 

Edit. Forgot to mention I added a patch surface I've selected in the 3d contour op to stop machining the inside of the pocket. It's selected on the geometry tab under model so on this op sees the patch, it's not selected in the setup.

Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

EESignature


1 Like

HughesTooling
Consultant
Consultant

@seth.madore  Can you take a look at this design. When I  first tried to generate a toolpath I got this.

before.png

After investigating I found an extra body that was hidden got selected while creating the setup. Seems to be because the folder is hidden but the body still has it's light bulb on. I think a body that's not visible because it's folder is hidden should not get selected.

Clipboard02.png

 

Thanks Mark

Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

EESignature


1 Like

seth.madore
Community Manager
Community Manager

Good catch, you are correct, it should not get selected. I'll write this up today and send it in


Seth Madore
Customer Advocacy Manager - Manufacturing
1 Like

Richie_B
Enthusiast
Enthusiast

Just the job! thanks for the help guys

 

Richie

0 Likes