Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

machine 0 not part 0

szkiXHQG3
Participant

machine 0 not part 0

szkiXHQG3
Participant
Participant

This is probably simple but I am realy new to this. On my drawing X0 Y0 doesnt end up being machine 0 The 0 ends up being the middle of the part so if the part is 2 inches long it is 1 inch in. I could compensate for this but there must be somthing I am doing wrong.

 

Using fusion 360

Thanks

0 Likes
Reply
Accepted solutions (1)
316 Views
1 Reply
Reply (1)

Anonymous
Not applicable
Accepted solution

edit the part setup and relocate the toolpath origin to where you want it

 

1 Like