Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Lynx 200B not liking G73 or any caning cycle

clarenceVH8JF
Enthusiast

Lynx 200B not liking G73 or any caning cycle

clarenceVH8JF
Enthusiast
Enthusiast

I just started working with this Lynx 200b with great luck till now. This post processor works great until it spits out a g73 code.

 

I've had problems with this machine and using cycles on the last software we used, so we just posted long form of the chip breaking cycle. Is there a way to force this post to do the same?

 

Thanks

0 Likes
Reply
171 Views
1 Reply
Reply (1)

Arun.rs
Autodesk
Autodesk

HI @clarenceVH8JF 

 

You can control the drilling canned cycle  in expanded form in latest Doosan post by using post property, https://cam.autodesk.com/hsmposts?p=doosan_turning

 

Arunrs_0-1684993974882.png

Uncheck the 'Use cycles' property in F360 and check the output.

 

Regards



Arun.RS
Technical Consultant - Post Processor
0 Likes