Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Leaving a Large wood Slab - with 55mm Spoil board cutter

andyC73F4
Participant

Leaving a Large wood Slab - with 55mm Spoil board cutter

andyC73F4
Participant
Participant

Hi All,  I am very new to Fusion 360 ,  I am trying to create a programme to level off twisted large wood slabs,  I have been trying to create a facing Operation to runs over the total dimensions of my slabs,  but what I really need is a program, which removes 1mm to 2mm per pass,  if there a simple way to program this ?  I can find the setting in the facing operation to lower per pass  ?

 

 

Thanks 

 

Andy

0 Likes
Reply
144 Views
2 Replies
Replies (2)

g-andresen
Consultant
Consultant

Hi,

Show pictures of your project
I can also imagine that the topic would be better placed in the Manufacture Forum.

 

günther

0 Likes

andyC73F4
Participant
Participant

Ok thanks you, this is my 1st post here , I will re post at Manufacture Forum. ..  

 

Here is a screen shot I am simply trying to remove 1/2mm per pass across the total width and length of a wood slab.  

This is my doing it manually with a router sled .- https://youtu.be/WvK1UC-qXPg?t=336

Screenshot 2021-02-10 at 09.49.51.jpg

0 Likes