Lathe threading confinement

[marshal.fitch]

Why is threading in turning the only operation that uses "confinement" instead of front/back with offsets?  I do quite a bit of single point threading on the lathe and that system is really confusing.

[seth.madore]

That's a good question, I wondered this myself when I started using Fusion for turning.

What say you @akash.kamoolkar ?

[akash.kamoolkar · Accepted solution]

We have a ticket to make threading limits consistent with the other turning strategies. i'll raise the priority.

Regards,

[marshal.fitch]

great, I'll be happy to see the change.  

[akash.kamoolkar · Accepted solution]

@marshal.fitch this was implemented in the Fusion update that recently went out.

Regards,