Keep tool down when cutting into sheet panel (mdf...)
Not applicable
02-13-2020
04:17 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
Hello,
Currently when I cut several parts in an mdf panel, the CNC does this,
1 - The tool goes down into the mdf,
2 - The tool cuts a piece
3 - The tool goes up
4 - The tool will reposition itself to cut another part, etc.
I would like to cut all the pieces without the tool going up between each of them or even repositioning itself, just that it follows the lines that are the same depth.
I've tried a lot of things but without success, is it possible?
Thank you in advance.
Fusion