Issue regarding swarf path generation time
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
During the generation of the swarf path I experience the following issue. After selecting contour pairs and asking Fusion to calculate the tool path, the process time increases greatly compare to normal. Upon "clicking machine other side", then have to endure 2+ min wait whilst it recalculates the tool path. Then if I need to change synchronisation process, have to wait for another 2 min + etc.
Is there anyway of speeding up this generation process? Often first try isn't the right one and the path requires adapting.
Solutions already tried:
-In an effort to speed it up, I have removed all other tool paths from this model and asked it to only generate one swarf path. This does not work and is not feasible to produce a programme.
-I have also tried using Fusion on different computers in case it was my PC, but I still experience the same issues
I appreciate there may be a simple solution to this issue that I have overlooked- but I would appreciate any suggestions any one has- this has got me tearing my hair out!
Thank you
-
Fusion