Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Help with retract ID turning

nordlund4V6AKB
Explorer

Help with retract ID turning

nordlund4V6AKB
Explorer
Explorer

Hi! 

 

I'm boring this ID and i want the boring bar to retract  15mm from model front in cycle. It seems it retracts fine the first cuts, but when its roughing out the grooving it stops to retract. I want it to retract all the time and i can't seem to find a way around it other than to program it by hand. 

0 Likes
Reply
Accepted solutions (1)
163 Views
2 Replies
Replies (2)

akash.kamoolkar
Autodesk
Autodesk
Accepted solution

@nordlund4V6AKB is this for chip evacuation? If so the recommended way to do it is by overriding your safe z parameter in the links tab to wherever you want to retract in Z and then set the "retraction policy" in the links tab to "full retraction".

 

Regards,



Akash Kamoolkar
Software Development Manager
0 Likes

nordlund4V6AKB
Explorer
Explorer
Thanks alot! That was exactly what I was looking for!
1 Like