Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Error: Internal CAM kernel error. Please report through your support channel.

Anonymous

Error: Internal CAM kernel error. Please report through your support channel.

Anonymous
Not applicable

this is a program that previously ran fine, i had to make a tiny change (g54 shift) which required me to regen all toolpaths, all but 2 regen'd fine except some chamfer paths. i tried rebooting the software, the computer. tried to make a new toolpath, they all give the same error. i'm dead in the water without this!

0 Likes
Reply
248 Views
1 Reply
Reply (1)

BjoernJohnsson
Autodesk
Autodesk

Hello

 

It's hard to say anything about the problem without looking at your file. Are you able to share it with me, either here on the forum, or to me directly?

 

Regards,

Björn Johnsson

Sr. Software Engineer for HSM CAM



Bjoern Johnsson

Principal Software Engineer
1 Like