Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Engraving width limit of 0,5 mm

goran_G
Contributor

Engraving width limit of 0,5 mm

goran_G
Contributor
Contributor

Fusion engraving limit.jpg

 

Is there any option to remove the engraving width limit of 0,5 mm?

 

I mean, the engraving setup is soo....lucking of.....everything. Can I engrave this with another setup, the tool is a V-bit (90° or 60°)?

0 Likes
Reply
Accepted solutions (1)
235 Views
4 Replies
Replies (4)

seth.madore
Community Manager
Community Manager

What tool definition do you currently have? Is your bit defined to a sharp point, or is there a flat?
Can you share your file?
File > Export > Save to local folder. Return to thread and attach the .f3d file in your reply


Seth Madore
Customer Advocacy Manager - Manufacturing
0 Likes

goran_G
Contributor
Contributor

Thank you for your fast replay. As I said, it's a V-bit, so it's sharp 90°.

 

And here's the file...

0 Likes

seth.madore
Community Manager
Community Manager
Accepted solution

It's not actually defined as a sharp tip.

Set that to zero :slightly_smiling_face:

 

2019-09-26_15h42_19.png


Seth Madore
Customer Advocacy Manager - Manufacturing
0 Likes

goran_G
Contributor
Contributor

Ok thank you, that's my obsession with "everything must be perfect!". I remember measuring that bit for 10 minutes.

 

But anyhow, that engraving setup need some features. Couldn't you just copy some code from the defunct Artcam? Those are mostly math formulas. I played a few weeks with Artcam and was a delight for woodworking.

0 Likes