Deburr Toolpath - Excluded edges not cleared when switching to Selected edges

[a.laasW8M6T]

Today while programming a deburr edge, I selected the edge I wanted to deburr, then realised I still had the "edges to deburr" mode set to automatic, so I had actually selected the edge to exclude.

so I switch the "Edges to deburr" to "Selection"

I then found I couldn't pick the edge as it was still selected as an "edge to exclude" but you cannot see that it is selected as such.

I know I should have Cleared the selection first but you would think that when switching modes, any previous selections would be cleared or ignored.

Not really a Bug more of an improvement that could be made

[peter.lockyer · Accepted solution]

Our apologies @a.laasW8M6T, this is definitely a bug on our side, it's been annoying us internally too.  We've recently fixed it in our internal builds, so you'll see it resolved in a subsequent release (not necessarily the next one).