Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Challenge exercices 2: Introduction to 3D Modeling for Manufacturing > Parametric modeling in Fusion 360: Sketching

43687269737469616e
Participant

Challenge exercices 2: Introduction to 3D Modeling for Manufacturing > Parametric modeling in Fusion 360: Sketching

43687269737469616e
Participant
Participant

Hello fellow kids,

 

The challenge exercice mentioned at the tittle, ask me to do a loft on a file that is a semisphere and a 4 sided prism. I tried to make 2 construct planes. One for de base of the cube an another for the tip of the semisphere. I did 2 sketches, one rectangle at the base and a point on the tip. Then I applied a loft, but the edges are sharp, how I round It? I tried to put a fillet, but is not working as I expect, and I feel that I'm missing something.

 

Thank you in advance ^^

0 Likes
Reply
Accepted solutions (1)
293 Views
2 Replies
Replies (2)

engineguy
Mentor
Mentor
Accepted solution

@43687269737469616e 

 

Have you tried putting the fillet on the corners of the base rectangle ??

1 Like

43687269737469616e
Participant
Participant

Yes, finally I got it, I was to obsessed only doing the loft, and I was putting the fillet after the loft and not before. Finally few minutes before going to sleep, I tried putting the fillet first a the base.

 

Thanks!

1 Like