- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
Please forgive the link. The file is to big to upload.
I am using morph spiral in this CAM. I cant get the morph to cut to bottom depth on some parts. Strange is the 2 corner parts are identical, one being the mirror of other. The top right part morph operation goes to bottom depth set at -.71 in. The lower left does not go to bottom depth.
Please help. I cut parts out of 3/4 in plywood. I then use a stack lamination to make a product.
I have done this with success many times. Today this problem reared for first time. I have checked depths, setups, and tried scallop, parallel, (not shown,) with same failure.
Sincere thank you for spending time reading and replying to this post. JR
Solved! Go to Solution.
Fusion