Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

CAM Simulation broken?! Not showing 'In Control'

Anonymous

CAM Simulation broken?! Not showing 'In Control'

Anonymous
Not applicable

Hi!

 

In the toolpath preview it shows that the last cut is done with compensation on, but when simulating it's showing like it's not compensated! Also the diameter of this tool is set as compensation point but in the preview it's below the programmed path.

 

Anyone an idea?

------

I think it's just showing the center of the tool after an another look

 

 

CoertHFT_0-1672932893943.png

CoertHFT_1-1672932922104.png

 

0 Likes
Reply
Accepted solutions (1)
271 Views
3 Replies
Replies (3)

seth.madore
Community Manager
Community Manager

It's showing the multiple passes that are taking place, is it not? 

2023-01-05_12h44_35.png

Perhaps I'm missing your question....? 


Seth Madore
Customer Advocacy Manager - Manufacturing
0 Likes

Laurens-3DTechDraw
Mentor
Mentor
Accepted solution

During simulation, the center of the tool is always shown as the cutter path.

Laurens Wijnschenk
3DTechDraw

AutoDesk CAM user & Post editor.
René for Legend.


1 Like

Anonymous
Not applicable

Thanks, I found out a bit later that day! I first thought it showed as an 'in computer' toolpath but later I noticed the small perpendicular lead in

0 Likes