Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Backside Chamfer around Tabs

jesseatbettercnc
Contributor

Backside Chamfer around Tabs

jesseatbettercnc
Contributor
Contributor

Hi all!

 

I'm programming a part where I am using tabs, and I am wanting to do a backside chamfer as well. Issue I am having is, it is trying to go up over and down around the tabs, is there a way I can make it pickup and clear the tabs so it's not cutting into my part?

 

dukejcdc_0-1605331616924.png

 

0 Likes
Reply
Accepted solutions (1)
310 Views
3 Replies
Replies (3)

seth.madore
Community Manager
Community Manager
Accepted solution

No, unfortunately. The tabs are not really being created as a model that can be programmed around. For it to pick up and drop back down, you'd be better off going into the Model space and actually adding the tabs to the model. Sorry, I'm sure that's not what you wanted to hear...


Seth Madore
Customer Advocacy Manager - Manufacturing
0 Likes

Marco.Takx
Mentor
Mentor

Hi @jesseatbettercnc,

 

Like @seth.madore said, it isn’t possible with the standard toolpath. 
for the back chamfering you could draw some sketch geometry within the Design workspace that describe the toolpath you are after.  
This is the only way to get your chamfer on the backside. 

If my post answers your question Please use Accept as Solution & Kudos This helps everyone find answers more quickly!

Met vriendelijke groet | Kind regards | Mit freundlichem Gruß

Marco Takx
CAM Programmer & CAM Consultant



0 Likes

jesseatbettercnc
Contributor
Contributor

Not a problem! I had a feeling that was the case. That would be a very specific feature haha

0 Likes