Amada post not putting in decimals
Not applicable
10-25-2021
02:41 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
good afternoon,
I run an amada emlk3510 at work, and have tried making some programs for personal side project stuff on fusion 360. when I use the amada laser post it seems to miss decimals on numbers that would be xxx.000 as in the snip below. where there isn't a decimal point after a number the machine goes in a straight line to the edge of the part
Am I just missing a setting somewhere?
Fusion