Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

2D contour problem

kamil.malec94
Advocate

2D contour problem

kamil.malec94
Advocate
Advocate

Hello,

 

Please see attached f3d file. 

 

I cannot seem to generate a toolpath that would mill constantly in -Z. My path makes 0.040 step and then does a finishing pass at the same level. I would like it to run in constant -Z (helix milling). It usually works on circular parts with the "BORE" milling operation, but it does not work here bacause it is  a slot - this is why I used "2D CONTOUR". 

 

I would appreciate your help!!

 

Thanks,

 

K

0 Likes
Reply
Accepted solutions (1)
505 Views
2 Replies
Replies (2)

LibertyMachine
Mentor
Mentor
Accepted solution

Turn off Multiple Depths on the Passes tab. You have Ramp turned on as well as Multiple Depths. 


Seth Madore
Owner, Liberty Machine, Inc.
Good. Fast. Cheap. Pick two.
0 Likes

kamil.malec94
Advocate
Advocate

Thanks for the help!

 

0 Likes