Not applicable
01-31-2019
09:58 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
There were no error messages. I selected open profile for the 2D adaptive clearing toolpath, the stock is defined as a solid body and the part is defined as a solid body. The stepover for the 0.5" cutter was set at 10% width and 0.5" depth or axial cut.
I program at high feedrates because I am counting on the stepover being consistent and maintained. In this case there were some full width cuts and this almost stopped the spindle on my machine. Luckily I was standing at the control.
Please look operation "2D Adaptive Issue Toolpath" under "Setup4".
Download link - https://a360.co/2UscxNi - Can't find the option to save as fusion360 external file.
Solved! Go to Solution.
Fusion
