trace toolpath heights problems

[beug4133]

I am trying to engrave this logo on part. wcs is set to model top (Z). I dont understand heights tab in set up ,there is no bottom tab, what do i need to do to engrave 0.005 depth? thanks

[seth.madore]

When using Trace, we want to use "Axial Offset" in the Passes tab:

 

[engineguy]

@beug4133 

There is no Bottom height setting in Trace, to change depths use the "Axial Offset", if you want to go deeper tthen set a Negative value, like -0.005 for example.

Hope that helps 🙂

Regards

Rob

[beug4133]

Than youvery much!!