Trace toolpath creates small segments

[marcoCAGYK]

Hello,

I have a proble with Trace toolpath, when it works on a radius it creates small segments in G1 instead of create a radius in G2 or G3.

I have verify the geometry using the contour toolpath and it works in G3 on the radius.

So there is a way to change the setting of trace toolpath and use G2 or G3 in the radius instead of small segments in G1?

Thanks in advance

[LibertyMachine]

Have you tried turning on Smoothing?

[marcoCAGYK]

Yes, but it change only the segments length

[LibertyMachine]

What machine, control and post processor are you using?

Could you share the file here? 

File > Export > Save to local folder. Return to thread and attach the .f3d file in your reply

[marcoCAGYK]

I using a Fanuc control with standard Fanuc post. But I don't think that is a post process problem, because the contour work perfectly
Is not necessary post the file you can prove it in every circular path

[Steinwerks]

Is the geometry derived from a spline or is it a true arc?

Trace is also not good at smoothing arcs on the G17 plane, as it's really more of a '3D-2D Contour' toolpath and does much better in G18/19 planes. Are you tracing in 3-axis movements or just 2-axis?

[marcoCAGYK]

I have the same problem in both case, also in a very simple case like the photo attached. Yuo can see the small segments on circular path

[marcoCAGYK]