Stock outside of center Mill/Turn setup

[endicott.12]

Hello,

Please see attached picture. 

I am trying to do a mill turn setup but the stock isn't wanting to stay in the center. 

Thanks

[Garrett_Wade]

Not sure whats going on without looking at the file but you could try drawing your stock in the design side then select it "from solid" in your setup.

[engineguy]

@endicott.12 

Looks like you have selected one of the faces for the Z axis so that is where the stock is being centered, try going to your Origin and selecting the Z axis there instead of on the Model, worth a try 🙂

[seth.madore]

Would you be able to share your Fusion file here or privately?
File > Export > Save to local folder, return to thread and attach the .f3d file in your reply. To share the file privately, it's the same process, but email it to me: seth DOT madore AT autodesk DOT com

[endicott.12]

I'm sorry I have been inactive on this thread. I have been very busy.

I got it to work it just took a lot of trial and error with the setup. 

I believe I had to set my stock up while I was in a turning setup then I had to change it to a Mill/turn

Thanks