slope cut

[Anonymous]

hi 

very new to fusion and about to cut my first project.

i have designed a box with a sloped front to it which is where i am getting stuck.

I have created the model and tool path for the basic contour operation but can't work out how to create the angled cut on the finger joints.

any help and advice really appreciated angled finger joints

[difalkner]

If I was building this I would build a fixture to hold the boards at the angle specified and machine it that way.  I don't think you'll be pleased with the fit and quality if you try to machine the slope with the boards flat on the spoilboard.

My $0.02

David

[johnswetz1982]

I would just use 2D contour with a 45 degree chamfer bit. That would work on outside contours. However, how do you plan to get the sharp inside corners?  I would just design stuff with the radi of the cutter I am using or larger.