Simulate not working right

[infinitemach]

I created a simple project in F360, created a manufacturing setup and added the tool I need to use to my library. I defined an initial contour cut for the basic shape and ran a simulation. That worked, but when I try to run the simulation again, nothing seems to happen. The display sort of flashes like the simulation is running extremely fast and the tool does not appear to move at all. It has been a while since I have used F360, so I'm having a bit of stumbling here. 

[a.laasW8M6T · Accepted solution]

Sounds like maybe you have the speed slider all the way to the right?

Also note that center position is slowest and to the left of center will simulate in reverse

[infinitemach]

Ha! That was the problem. I had it all the way to the left. Thanks!