S&S no longer milling what is used to

[FrodoLoggins]

EDIT: PEBCAK

So as you can see in my previous post here the S&S toolpath is milling pretty much all the radii as intended:

But now just a few minutes later the toolpath looks like this:

Much less milling going on. All I did was add one more face to be avoided. To double check that's all I changed, I downloaded the .f3d file I uploaded in that previous thread where the S&S toolpath was milling everything I needed it to. But to my amazement, even with that original f3d file (where the S&S toolpath milled what I wanted it to), the radii are now not getting milled:

[Chris.Barnes.ADSK]

Hi FrodoLoggins

I downloaded the f3d file attached in your other post and took a look at it. I could not see any issues with the cutting moves. I duplicated the toolpath, cleared it and regenerated it and still had no issues.

Are you sure you didn't accidentally turn off the visibility of the cutting moves? As the lead and link moves in your screenshot are still in the same place. You can find the control of the toolpath move visibility from the navigation bar at the bottom of the screen.

Chris