Probe WCS (G54) then move it in Y 0.012

[Sean3073]

To all thank you in advance for taking the time. 

Looking to probe a bore for WCS, then shift it 0.012 in Y.

Reason... I made an expensive pallet and the parts are flexing in the pallet. To correct the tool paths, I need to shift WCS. Not sure if this is possible but looking for a solution.

Respectfully, Sean

[programming2C78B]

You can either sketch a cylinder body .012" off center and probe "that", or do a passthrough that modifies G54 Y by .012"

[Sean3073]

I have only been at this a couple of years. Can you give an example of a pass thru / what it looks like?

[programming2C78B · Accepted solution]

it depends on your controller. Check your manual to find the Macro variable table that covers your Work offsets. On a haas its something like #5330