Post Processor for a 1998 Trak AGE 3

[Anonymous]

I am trying to get fusion 360 to work with a 1998 trak age3 controller retrofit. I have already talked to an autodesk representative, and he sent me the harvard_prototrak post processor (attached). When the code generated by this post processor is loaded on the controller it prints "sqrt: _DOMAIN error" (picture attached). Niether the generic prototrak post processor nor any I have found will generate working g-code, a this point, anything would be helpful. I can also post working g-code generated by camworks if it would be helpful.

Thanks!

[dave.anderson]

You may have better luck on this topic in the Post section of the HSM forum: http://cam.autodesk.com/posts/

[jeff.walters]

you might also check on the post site there are 2 that might work 

http://cam.autodesk.com/posts/ 

[Anonymous]

Any more development on this? Just acquired an AGE 3 prototrak and the generic posts definitely don't work. Getting an error saying bad g-code.