Post Processor Error Help

[hphan7LN5B]

Hi everyone, 

I got this error message when trying to post out the NC file:

https://a360.co/4cXc9iQ

Appreciated for any help.

[aju_augustine · Accepted solution]

Hi @hphan7LN5B,

It appears that the machine rewinds are not currently enabled in your post processor. To rectify this situation, you can follow the instructions provided in the following article on Autodesk's technical support page:

https://www.autodesk.com/support/technical/article/caas/sfdcarticles/sfdcarticles/How-to-enable-mach...

I hope this information is helpful to you. If you have any further questions or run into any issues, please don't hesitate to ask.

[hphan7LN5B]

I've seen that article, but it does not have the feature as shown on my side. I downloaded a new version of the post processor and it solve the issue.

Thanks for help.