OKUMA OSP-P300MA POST

[Anonymous]

I am needing a good post for OSP-P300MA on an OKUMA genos M560-V. this is my first part using Fusion 360 for this mill and i find out the peck drill and tap cycles are not right. tap should be G284. is there a post out there for this 4 axis mill?

[Tom.Hemans]

Hi @Anonymous,

If you can't find a post on the forums or in the Post Library, then you can try contacting one of our CAM partners via the Service Marketplace who can provide a post for your specific machine.

Tom

[Anonymous]

Tom, thanks for the reply. i found a post in the post library but when i edit it and try to import it i get a invalid post warning. what am i doing wrong?

[Tom.Hemans]

@Anonymous what edits have you made to the post?

[Anonymous]

Tom, i changed G84 to G284. coolant through spindle on M51 off M209. machine retract points were in inch and i changed it to MM.

[Tom.Hemans]

@Anonymous,

Can you you attach the post you have modified and a copy of the original post so I can see what the differences are and test for the same invalid post warning message?

Tom

[Anonymous]

Tom,

sorry for the delay, i will attach both versions of the post. thank you for the help.

[GeorgeRoberts · Accepted solution]

Hi Kevin,

The issue with your edited post is on line 305:

var useG284 = True; // use G284 instead of G84

True should be in lowercase, like this

var useG284 = true; // use G284 instead of G84

Hope this helps!  

[Anonymous]

George,

that did it, such a small detail that i was totally overlooking. thank you very much.