Manufacture help

[manoloss]

Dear Sirs, 

I have been working with Fusion for some time and I am very happy with the program, I have done many simple projects with great success.
I am repairing a 1930 Nash car and rebuilding the brakes for which I need this part.
I honestly can't imagine how to make the tool paths.
I have a small cnc milling cutter as well as flat and round drill bits.
I would be very grateful if anyone could help me create the cut tool paths.

Im starting with a square carbon steel block
I send you a cordial greeting and my thanks in advance.

[nordlund4V6AKB]

Hi!

I've created some rough strategies for you. They're not fully optimized regarding feed rates and cutting data, so please double-check those before running the program. Also, I wasn’t able to resolve all corners and edges, but hopefully this gives you a starting point. Also be aware of loads and stepdowns and change if needed.

Best regards,

[nordlund4V6AKB]

Also, It sounds like you have to buy some more milling tools if you want to make this part. 

[manoloss]

Dear nordlund4V6AKB,
You're a great person. Thank you for taking the time to help me. I never would have been able to do this without your help.
I'll try it next week and tell you about my experience.
Thank you so much.

[nordlund4V6AKB]

Make sure you do a fixture for second setup! 

[manoloss]

Thanks nordlund4V6AKB

Im figure out how Im going to make it, but I think this part will be easear

Best regards