Manual NC for turning parts

[Anonymous]

I need to turn a part around and machine the second side of a part in the lathe.  I did some research and found a post about adding a manual NC but it seemed a little cumbersome.

  Since the post was 3 years old and second side machining is fairly common I was curious if an easier method had been created inside of fusion? 

[seth.madore]

Manual NC at the end of the first setup, second Setup to establish new origin. Post out the setups together, or create an NC Program of both ops and post that out.

[Anonymous]

So I still have to copy and paste the action in the g-code?

[seth.madore]

Yes. Whether that is a Manual NC for Comment, or simply an M0