Machine builder haas ST10-Y

[crepin.baptiste]

Hi,

I try to build the a four axis lathe , haas ST10-Y (XYZ - C)

But the X axis is not perpendicular to Y.

How can'I set it in machine builder configuration ?

Thanks

 

[boopathi.sivakumar · Accepted solution]

Hi @crepin.baptiste 

Currently machine simulation / machine builder don't have support for turnmill machines.

[engineeringQCQFN]

I'm looking forward to turning improvements, the machine builder is already released and it seems turning was forgotten, the gap between milling and turning is huge

[bruno.martyA5RNA]

@boopathi.sivakumar 

Do you if now in 2025, machine simulation for turn- milling mchine is available ? I have an HAAS ST10-Y and I want to simulate.

Thanks!

[seth.madore]

No, but it's high on our list of priorities for upcoming development!

[marutishiv]

It's 2025 and it is high time that the gap reduces between milling and turning capabilities of Fusion 360.

[joao_valerio2SAA3]

Where did you get the 3d model of your machine?