Late 90's HAAs VF-4 no post

[ryanasorg]

We have a late 90's VF-4 lathe and there is no VF4 option in fusion 360 . one forum said to use HAAS-PRE NGC. When trying this my machine immediately says "feed limit exceeded:" IS there someone with knowledge of this issue that could help me figure out whether this is a faulty post or if i made something wrong in the toolpath? in my old version of mastercam 9 i have no issues running this mill, fusion is very new to me. PLease see attached post and let me know of any ways you can help 

[seth.madore]

---

@ryanasorg wrote:

We have a late 90's VF-4 lathe 

---

Come again?

[seth.madore]

Regardless of the mill/lathe question...

Could you share an NC program that you created with MasterCAM 9?

I'm betting it's the feedrate of 650 ipm, as your machine might not be able to reach those numbers.

[programming2C78B]

this is a toolpath or post setting (high feed selection), not machine side. Our tm2 also alarms out if anything is over 200.